Style Generator Set has a voltage change rate of approximately 20-40%. Industrial and household load requirements remain essentially constant. Therefore, as the load current increases, the field current must be adjusted accordingly. Although the trend of the adjustment characteristics is opposite to the external characteristics, for inductive and purely resistive loads, the trend is rising, while for capacitive loads, the trend is usually decreasing.
1. When the Steyr generator is working, the operation between two fuel injections is called a work cycle. In four strokes, this cycle needs to be accomplished by four different strokes of the piston, namely suction, compression, expansion and exhaust.
2. Combine suction and exhaust with compression and expansion, which is a two-stroke unit. During the two-stroke cycle, the piston rises from the bottom (both bottom dead center), the intake port and the exhaust valve are open, fresh air is charged into the cylinder, and the residual exhaust gas from the last stroke can be exhausted;< p=""> 3. When the piston is running up to about one-fifth of its stroke, the intake and exhaust valves are closed, and the temperature and pressure rise to a very high value;
4. When the piston reaches the top of the stroke (ie, top dead center), the fuel valve injects fuel into the high temperature air in the cylinder, the fuel burns, and the pressure rises rapidly, whereby the expanded gas forces the piston Move down during the power stroke;
5. When the piston moves down to half of the stroke, the exhaust valve opens, and the high temperature gas begins to flow out due to its own pressure. At the fresh air entering the port, the air inlet opens as the piston descends further, and another cycle begins.
Steyr Generator Set Precautions
Steyr generator sets and other electrical equipment usually have a shipping box. When handling, care should be taken to attach the lifting cable to the appropriate part of the machine and lift it gently.
When lifting the unit for installation, first connect the protruding lifting points on the chassis, then check if it is hung, if there is any crack in the welding, and if the bolt is tightened Wait.
Once the Steyr generator set is off the ground, a guide cable is used to prevent the wire rope from kinking or machine rocking. When the unit is lowered, place it where it can carry the weight of the generator.
If the generator is to be lifted, a single-point suspension should be installed. The standard covered machine has a single-point suspension. When the unit is shipped to its destination, it should be placed in the warehouse if it needs to be stored.
If there is no warehouse to be stored in the open air, the cabinet should be raised to prevent rain erosion. The box should be covered with rainproof shed to prevent sun and rain. Leaking damage to the Steyr generator set.
- Inspection project on Shangchai diesel generator set
- How to maintain the Steyr diesel engine unit in winter
- What are the problems with the inferior Weifang generator set?
- Safe operation of Yuchai generator set
- Notes on the assembly and unloading of silent trailer generators
- National diesel generator set noise treatment scheme
- How should we maintain the Weifang generator set in the cold winter?
- Silent box reduces the noise impact of Shangchai diesel generator set
- How much is the maintenance of low noise generator set
- How to use Steyr generator sets and precautions
- Detailed structure of silent trailer generator set
- Styre diesel engine unit basic knowledge question and answer
- Maintenance and maintenance knowledge of fuel generator sets
- Silent trailer generator set is very convenient
- Steyr generator set working principle and system composition
- Several sources of noise for silent trailer generator sets
- How to store fuel generators in winter
- Noise source of Shangchai diesel generator set
- Steyr generator test machine inspection project
- Common fault handling method for Cummins diesel generator sets